ORing AP Model |
IGAP-620+ |
Physical Ports |
|
10/100/1000 Base-T(X) Ports in RJ45 Auto MDI/MDIX |
2 |
5-Pin Terminal Block |
2(DI x 4 and DO x 4) :
Dry Contact:
On: short to GND, Off: open
Wet Contact (DI to COM/GND):
On: 0 to 3VDC, Off: 10 to 30VDC |
RS-232 Console port in DB9 |
115200, 8 ,N ,1 |
Antenna Connector |
2 |
PoE P.D. Port |
Present at ETH2
Fully compliant with IEEE 802.3af Power Device specification
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min |
WLAN Interface |
|
Operating Mode |
AP/Bridge/Repeater/AP-Client |
Antenna and Connector |
2xReverse SMA Female |
Modulation |
IEEE802.11a: OFDM
IEEE802.11b: CCK/DQPSK/DBPSK
IEEE802.11g: OFDM
IEEE802.11n: BPSK, QPSK, 16-QAM, 64-QAM |
Frequency Band |
America/FCC: 2.412~2.462 GHz (11 channels)
5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels )
Europe CE/ETSI: 2.412~2.472 GHz (13 channels)
5.180~5.240 GHz ( 4 channels ) |
Transmission Rate |
802.11b: 11, 5.5, 2, 1 Mbps;
802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
802.11n: up to 300Mbps |
Transmit Power |
802.11a: 12dBm ± 1.5dBm@54Mbps
802.11b: 17dBm ± 1.5dBm@11Mbps
802.11g: 16dBm ± 1.5dBm@54Mbps
802.11gn HT20: 15dBm ± 1.5dBm @MCS7
802.11gn HT40: 14dBm ± 1.5dBm @MCS7
802.11an HT20: 12dBm ± 1.5dBm @MCS7
802.11an HT40: 11dBm ± 1.5dBm @MCS7 |
Receiver Sensitivity |
802.11a : -76dBm ± 2dBm@54Mbps
802.11b : -85dBm ± 2dBm@11Mbps
802.11g : -76dBm ± 2dBm@54Mbps
802.11gn HT20:-75dBm ± 2dBm@MCS7
802.11gn HT40:-72dBm ± 2dBm@MCS7
802.11an HT20:-74dBm ± 2dBm@MCS7
802.11an HT40:-71dBm ± 2dBm@MCS7 |
Encryption Security |
WEP: (64-bit ,128-bit key)
WPA/WPA2 PSK :TKIP and AES encryption (802.11i)
802.1X/RADIUS Authentication supported |
Wireless Security |
SSID broadcast disable and enable |
Protocol Support |
|
Protocol |
ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D) |
LED Indicators |
|
Power Indicator |
3 x LEDs, PWR1(2)(PoE) / Ready:
Red On : Power is on and booting up
Green On : Power is on and functioning Normal |
10/100/1000Base-T(X) RJ45 Port Indicator |
2 x LEDs,
LNK/ACT:Green for port Act.
Speed: Green for port Link at 1000Mbps
Amber for port Link at 100Mbps.
Off for port Link at 10Mbps |
WLAN LEDs |
Green Solid On: RF on, Blink: data transmitting
Green for WLAN Strength: 1<25%, 2<50%, 3<75%, 4<100% |
Fault |
1 x LED, Red for Ethernet link down or power down indicator |
Fault Contact |
|
Relay |
Relay output to carry capacity of 1A at 24VDC |
Power |
|
Redundant Input Power |
Dual DC inputs. 12~48VDC on 6-pin terminal block |
Power Consumption (Typ.) |
8.5 Watts |
Overload Current Protection |
Present |
Reverse Polarity Protection |
Present on terminal block |
Physical Characteristics |
|
Enclosure |
IP-30 |
Dimensions (W x D x H) |
74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.) |
Weight (g) |
1155 g |
Environmental |
|
Storage Temperature |
-40 to 85°C (-40 to 185°F) |
Operating Temperature |
-25 to 70°C(-13 to 158°F) |
Operating Humidity |
5% to 95% Non-condensing |
Regulatory Approvals |
|
EMI |
FCC Part 15, CISPR (EN55022) class A |
EMS |
IEC61000-4-2 (ESD), IEC61000-4-3 (RS), IEC61000-4-4 (EFT), IEC61000-4-5 (Surge), IEC61000-4-6 (CS), IEC61000-4-8, IEC61000-4-11 |
Shock |
IEC60068-2-27 |
Free Fall |
IEC60068-2-31 |
Vibration |
IEC60068-2-6 |
Safety |
EN60950-1 |